CUCM 8.6 Replication cluster status 3

[cristian.munoz]

Hi Guys

I have the replication cluster status 3. All nodes are in status 3.

Someone have the procedure to get replication cluster status 2?

TIA

Cristian

[Leo Salcie Tejeda]

Cristian, as I told you before, reboot cucm03 that will restart all service, it should solve the problem.

Regards

Please remember to rate useful posts clicking on the stars below.
Favor calificar todos las respuestas útiles dando click en las estrellas de mas abajo.
___________________________________________
LinkedIn Profile: do.linkedin.com/in/leosalcie

[Aman Soi]

Hi Cristin,

Any updates, is your problem resolved ?

regds,

aman

[nikshah]

Christian,

Try running utile network host , ip add , fqdn...

I am pretty confident that server showing offline means that something is fishy with that box, try power cycling it and see if it helps.....

Sent from Cisco Technical Support iPad App

[Aman Soi]

Hi Cristian,

Try rebooting server as suggested else open a case. I got stuck in a similar kind of issue where even after performing the steps mentioned above, we were not able to bring the replication count as GOOD.

We had to rebuild almost three servers in a cluster of four.

regds,

aman

[cristian.munoz]

Dear Aman

The issue was solved, using the follow command:

admin:utils network connectivity  cucm03

This command can take up to 3 minutes to complete.

Continue (y/n)?y

Running test, please wait .........

Network connectivity test with cucm03 completed successfully.

admin:

Then,

admin:utils dbreplication reset cucm03

Repairing of replication is in progress.

Background repair of replication will continue after that for 30 minutes....

OK [10.240.0.12]

admin:

After a few minutes..

admin:utils dbreplication runtimestate

DB and Replication Services: ALL RUNNING

Cluster Replication State: REPLICATION RESET cucm03 Started at 2013-05-27-18-19

DB Version: ccm8_6_2_22900_9

Number of replicated tables: 541

Cluster Detailed View from PUB (3 Servers):

                                           PING                          REPLICATION          REPL.          DBver&           REPL.          REPLICATION SETUP

SERVER-NAME          IP ADDRESS            (msec)          RPC?          STATUS               QUEUE          TABLES           LOOP?          (RTMT) & details

-----------          ------------          ------          ----          -----------          -----          -------          -----          -----------------

cucm01          10.240.0.10          0.037          Yes          Connected          0            match          Yes            (3) PUB

cucm02          10.240.0.11          0.085          Yes          Connected          0            match          Yes            (3) N/A     

cucm03          10.240.0.12          0.197          Yes          Connected          0            match          No             (0) N/A     

admin:

Finally after a one hour...the replication passed to state = 3.

Thanks for you help.

Regards.

Cristian

[Aman Soi]

Hi Cristian,

Thanks for update.

Did u run utils network connectivity command on Publisher?

regds,

aman

[cristian.munoz]

Dear Aman

Yes, correct. All the commands were run on pub.

Regards

Cristian

[Aman Soi]

Good... problem got resolved.

regds,

aman

[greg.zboran1]

I have some logs from a Cisco Phone that seems to unregister from the CCUM. Below is the trace log. I am trying to understand what Status=2 and status=3 means. Does anyone know what this means as the phones stop receiving messages with these status changes. Thanks.