Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We are getting reports that default wallpaper on our 8861 phones have changed. we are trying to determine what might cause this. This is on the phones that are already registered. Any ideas what could have caused this change?
Hi all, i have some 6945 and 6941 IP Phones which getting no Ringtones from TFTP. You can only choose the default ringtones Chirp1 and Chirp2. Firmware is 9-4-1-3SR2 . CUCM Version: 11.5 The Phone is getting the Ringlist from CUCM (Wireshark trace)...
I have a CME Router 2921 connected to SIP Router "Peer to Peer", which is giving me VOIP Service. i can make inbound calls normal and i can hear ringback tone when tested incoming calls from my Mobile or any landline Phone. Issue is when i try to m...
Hi, I can't delete one device pool on CUCM. This is the message that I received: "Delete failed. The pkid column in the devicepool table in the database is being referenced from another table. Please check the dependency records, remove...
We're planning on spliting our UC environment (CUCM, UCXN, UCCX) across a WAN. By looking at the SRND's for each, I estimate that we'll need 3.7Mbit bandwidth on the WAN just for intercluster communication for all the servers. We have a 6Mbit conne...
Dear AllIt's really hard to understand the CUCM trace log, is there any document can help to understand it ?I know there is a sofeware VLT, it can translate the SDI trace file to easy understand form,but I think this is not good engough , and this so...
I'm reading the official certification guide for CIPTV1 and this is driving me crazy! Some documents considered them the same and therefor interchangeable words, while the official guide obviously does not so I would like to know exactly what's the d...
I'm quite sure this has been answered previously but I've been unable to find. I have a customer who has a CME box with FXS ports and a PRI interface. The customer wishes to put an analog phone in a public location that makes only outside calls with...
Hi All, Cisco Phones supports Inband dtmf ?? Setup Phone --> CUCM --> CUBE ---> Service Provider 1)We are doing the SIP Integration with service provider (codec G711), where some calls are negotiated with rtp-nte and some calls are negotiated with i...
CUCM 11.5 I watched a Cisco Live presentation regarding ILS and global dial plan replication and I did not hear one mention of the actual directory number being advertised with ILS. The only thing I heard mentioned was being able to advertise these ...
Hi Everyone , just started learning CUCM, managed to install CUCM 11.5, Unity and CUP in the lab. The systems are talking to each other, there is no AD integration, have created local users in CUCM. The Unity has AXL integration configured to pull us...
We have two PRIs for local inbound/outbound calls and a T1 for TFNs and long distance outbound. We want to switch over the T1 to a PRI as well. My phone provider is asking if we're going to be using NI2 protocol. I'm not sure if we will be. I wou...
I see several post regarding Zebra TC51 with Jabber installed.. We loaded and configured Jabber Ver 11.9 then 12.x on a TC51 Jabber phone control appears to function as expected however the Directory is not connected.. Tried UDS, BDI Service Prof...
