CUCM T1 CAS into an Adtran

[CARLO CALABRESE]

I have CUCM 7.1.5 and i have an adtran 850. i have connected the 850 via T1 CAS connection to a 2811 running mgcp.

I get calls inbound and out just fine. The only problem i have is that the calls show a call ID of unknown.

Is there a way to add an extention number to the port?

[linuxchild · Accepted solution]

Hi

are these checked under the port

Redirecting Number IE Delivery - Outbound

Redirecting Number IE Delivery - Inbound

[CARLO CALABRESE]

Thats on a PRI connection, this is a CAS so the ports are EandM

[paolo bevilacqua]

T1 CAS does not support outbound DNIS.

If you want it, and mnay more features, get T1 PRI instead.

Or you can ask telco to display a same number for all the calling extensions.

[CARLO CALABRESE]

I was trying to connect this site without upgrading the key system.

Thanks.

[paolo bevilacqua]

Possibly it will be less expensive, and more feature rich, to just install IP phones at the site, and then use the T1 capacity for voice and between offices.

[CARLO CALABRESE]

I found a way around it. I created a new partition and calling search space. I then created a translation pattern of @ and added the calling id for the system in that.

I have 20 sites like this so putting ip phones is not an option and it would cost to much to upgrade the systems to PRI.