06-05-2018 05:14 AM - edited 03-17-2019 12:57 PM
Hello ALL,
please advice me
is it possible to make transport protocol SIP over UDP between CUCM 11.5 and IP Phone 7841 ?
Solved! Go to Solution.
06-06-2018 05:56 AM
You ALWAYS have to configure the SIP profile and phone security profile for devices, they are MANDATORY fields. And those are two different settings in the device page.
Assign the phone security profile with UDP only to the phone you want.
06-06-2018 07:23 AM
Here you go..
Hope this Helps
Cheers
Rath!
***Please rate helpful posts***
06-05-2018 05:33 AM
Hi there
Please check this post. I hope you find the answer.
https://supportforums.cisco.com/t5/ip-telephony/cisco-7821-sip-over-tcp-only/td-p/2711507
Hope this Helps
Cheers
Rath!
***Please rate helpful posts***
06-05-2018 08:09 PM
Thanks a lot.
but I can not see how the non-secure profile is connected to the phone?
when configuring phone there are only standart sip profile.
I mean I want to change configuration of only one phone. not all of them.
06-06-2018 05:56 AM
You ALWAYS have to configure the SIP profile and phone security profile for devices, they are MANDATORY fields. And those are two different settings in the device page.
Assign the phone security profile with UDP only to the phone you want.
06-06-2018 07:23 AM
Here you go..
Hope this Helps
Cheers
Rath!
***Please rate helpful posts***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide