Dial plan between CME 2901 and Panasonic PBX

[Dmitri Popkov]

Good day, everyone!

At last, i've created a h.323 trunk between CME 2901 and Panasonic TDE-200. Calls between local phones are dial well.

On CME i have subscribers with phone number 501 and on Pan TDE-200 - 102. If I dial from 501 to 102 and from 102 to 501, everything is all right.

But, what config should i create to dial to, e.g mobile number 89151893116, through Pan TDE-200, which is connected to service provider through PRI card? Can anyone suggest me please

If i dial from 102 phone number (directly connected to TDE-200), I dial such sequence - 989151893116.

Thanks:)

[Chris Deren · Accepted solution]

You need to add dial-peers that match those digit strings and then ensure Panasonic can route the call out, i.e. ensure the configuration of the trunk has access to outbound routes.

Chris

[Dmitri Popkov]

Ok, thanks, tomorrow, i'll try. Panasonic TDE-200, can route calls with such configuration, cause i've another Panasonic TDE-100, which has h.323 trunk to TDE-200. And TDE-100 has access to outbound routes...