10-23-2012 12:16 PM - edited 03-16-2019 01:50 PM
Dear Friends,
What is the difference between DSP for voice calls & services ?
When I buy a VWIC card does it have DSP's on it, how do I configure it for voice calls and services ?
Does the command voice-card refer to the DSP's on the VWIC card ?
how do I configure DSP's on mother board?
Does DSP's used for voice calls ( not services ) register with call manager ?
Please advise...
Cheers,
Shaggy
Solved! Go to Solution.
10-23-2012 12:29 PM
Check out this post for explnation of dspfarm services vs. dspfarm
https://supportforums.cisco.com/thread/274844
voice-card refers to a module on a router, voice-card 0 means the motherboard and applies to both dspfarm and dspfarm services
Config examples on the above thread as well as many, many other trheads and cisco docs, just search for dspfarm
Does DSP's used for voice calls ( not services ) register with call manager ?
No, the circuit/port may register if MGCP is used.
HTH,
Chris
10-23-2012 12:29 PM
Check out this post for explnation of dspfarm services vs. dspfarm
https://supportforums.cisco.com/thread/274844
voice-card refers to a module on a router, voice-card 0 means the motherboard and applies to both dspfarm and dspfarm services
Config examples on the above thread as well as many, many other trheads and cisco docs, just search for dspfarm
Does DSP's used for voice calls ( not services ) register with call manager ?
No, the circuit/port may register if MGCP is used.
HTH,
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: