02-10-2014 05:10 AM - edited 03-16-2019 09:40 PM
02-13-2014 10:44 AM
Your CUE is configured for rtp-nte
ccn subsystem sip
gateway address "10.1.10.2"
dtmf-relay rtp-nte
end subsystem
ccn subsystem sip
Please change this to
conf t
ccn subsystem sip
dtmf-relay sip-notify
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
02-13-2014 06:06 AM
Hi
Check if you CUE is working properly, once that is not working fron inside
Cheers
Bruno Rangel
Please remember to rate helpful responses using the stars bellow and identify helpful or correct answers .
02-13-2014 06:10 AM
What do you mean by check from inside???
i have already checked its working fine....its pinging, I can open cli of cue,Gui also works fine.
02-13-2014 06:15 AM
I mean if it´s working from a Internal extension
mohd abdul malik wrote:
Not only i am facing this issue when i am calling from outside but also internally therfore am guessing this issue is related to configuration
Cheers
Bruno Rangel
Please remember to rate helpful responses using the stars bellow and identify helpful or correct answers .
02-13-2014 06:18 AM
nope its not working for internal extensions also.
Is my configuration alright??
02-13-2014 06:33 AM
Hi Abdul,
show run (From the CUE)
Regards,
Kevin
02-13-2014 07:04 AM
02-13-2014 08:36 AM
Abdul,
You didnt post the dial-peers for the CUE. Do you have sip notify configured on the dial-peer pointing to CUE on the UC520?
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
02-13-2014 09:28 AM
Hi Aokanlawon,
I have posted the dialpeer in my initial question, Please have a look.
02-13-2014 09:35 AM
Now i have also done the dtmf-relay sip notify configuration on the dial-peer voice 750 voip.
dial-peer voice 750 voip
destination-pattern 750
session protocol sipv2
session target ipv4:10.1.10.1
dtmf-relay sip-notify
codec g711ulaw
no vad
Still its not working
02-13-2014 09:43 AM
Hi
You received busy tone ? Post the output of debbug voice ccapi inout.
Also try no incoming called number . in your DP
02-13-2014 09:49 AM
02-13-2014 09:53 AM
Can you post your full sh run..What is configured on dial-peer 102?
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
02-13-2014 09:58 AM
02-13-2014 10:44 AM
Your CUE is configured for rtp-nte
ccn subsystem sip
gateway address "10.1.10.2"
dtmf-relay rtp-nte
end subsystem
ccn subsystem sip
Please change this to
conf t
ccn subsystem sip
dtmf-relay sip-notify
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide