E1 conenction is showing Deactivated

[sankarapuv]

HI

I need a help in E1 conenction is showing Deactivated.

Here is the scenario, where E1 conenction is connected to a pbx using Qsig.

The output are showing as below

Global ISDN Switchtype = primary-qsig

ISDN Serial2/0:15 interface

        dsl 0, interface ISDN Switchtype = primary-qsig

         **** Slave side configuration ****

    Layer 1 Status:

        DEACTIVATED

Layer 2 Status:

        TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED

    Layer 3 Status:

        0 Active Layer 3 Call(s)

#sh controller E1

E1 2/0 is up.

  Applique type is Channelized E1 - balanced

  Description: VOIP|Ericsson MD110|E1 ISDN|Y|||EQU-1-3-00|||V13|

  No alarms detected.

Any help is more appriciated.

Thanks

venkat.

[paolo bevilacqua]

isdn network side is configured under interface, not controller.

After which you have to shut/no shut.

[sankarapuv]

HI Paolo,

if i am not wrong, its already configured in the router.

encapsulation hdlc

no logging event link-status

isdn switch-type primary-qsig

isdn overlap-receiving T302 7500

isdn incoming-voice voice

please let me know if it is wrong. thanks

[paolo bevilacqua]

You may have the PBX in loopback causing this.

[sankarapuv]

HI Paolo,

I configured the interface as isdn network side, still no luck.

[Aman Soi]

Hi Pavan,

Did u try configuring Clock on router?

Can u cross-check the parameters one by one u have configured on router with EPABX guy since after u change network on your side EPABX needs to be on Slave ?

regds,

aman

[Aman Soi]

Hi ,

The network -clock are missing.

I doubt this is problem .You need to configure network-clock participate

regds,

aman

[sankarapuv]

Hi Aman,

sure i will try this and will get back to you.

[Aman Soi]

Hi,

it is slave configured

Global ISDN Switchtype = primary-qsig

ISDN Serial2/0:15 interface

        dsl 0, interface ISDN Switchtype = primary-qsig

         **** Slave side configuration ****

regds,

aman