10-04-2010 03:07 AM - edited 03-16-2019 01:08 AM
Hello,
I have some Linksys SPA941 and SPA921 SIP phones and I'm trying to setup a CME on a 2811 router with IOS: c2800nm-ipvoicek9-mz.124-24.T2.bin
The problem is the phones won't register on the CME, I also tried using X-lite and no luck either.
I keep getting this error:
VOICE_REG_POOL: Register request for (cisco) from (10.5.0.10)
VOICE_REG_POOL: Invalid destination pattern (cisco)
Here is the relevant part of my running-config:
=====================================
ip dhcp pool VOICE
network 10.5.0.0 255.255.255.0
default-router 10.5.0.1
domain-name voice.ulbsibiu.ro
dns-server 194.169.191.190
lease 0 0 30
!
!
voice service voip
allow-connections sip to sip
fax protocol cisco
sip
registrar server expires max 600 min 60
!
!
!
!
!
voice register global
mode cme
source-address 10.5.0.1 port 5060
max-dn 10
max-pool 10
authenticate register
!
voice register dn 1
number 1111
allow watch
name JAY
label 1111
!
voice register pool 1
id mac 000E.083B.6E9F
number 1 dn 1
dtmf-relay rtp-nte sip-notify
username cisco password cisco
codec g711ulaw
!
dial-peer voice 1 voip
destination-pattern 1111
session protocol sipv2
session target ipv4:10.5.0.1
session transport udp
codec g711ulaw
!
=============================
Can anyone help me out please?
Solved! Go to Solution.
10-04-2010 03:09 AM
Set authentication username and registration number to be all the same, eg 1111
10-04-2010 03:09 AM
Set authentication username and registration number to be all the same, eg 1111
10-04-2010 03:30 AM
it works now!
thanks a lot!!!!!!! i've been searching for a solution for the past 3 days, I never thought it would be that simple
10-04-2010 03:49 AM
Thank you for the nice rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide