09-06-2012 11:46 PM - edited 03-16-2019 01:04 PM
Hello All,
The eth0 on one of my MCS 7835 has failed. The server is a subscriber and has lost connectivity to the publisher. How can I resolve or bring up the eth1.
Thank you for your response.
09-07-2012 03:33 AM
Hi,
Can u please check whether command set network nic eth1 and set network ip eth1 is working or not from CLI of subscriber?
If yes,please share snapshot.
regds,
aman
09-10-2012 11:44 PM
Apologies for the delay.
The commands are not valid.
However, when I checked the display on the monitor, the message displayed is "bnx2: eth0 NIC Copper Link is Down" but the LEDs on the NIC (eth0) indicated there is connectivity and activity as the LEDs are green and amber (and blinking).
Kindly assist
Thank you.
04-07-2015 12:26 AM
Hello,
I know it was long time ago. Did you manage to solve that? I am facing the same issue
Regards
09-07-2012 05:05 AM
This answer would differ depending on the product installed, the version of that product, and whether this is IBM or HP hardware.
09-07-2012 07:34 AM
The product installed is CUCM, version 7.1.5 and IBM (7835 I2).
09-11-2012 05:09 AM
My suggestion :
On the CLI you type utils network failover
It act as a NIC teaming, if one fails the second will remain active.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide