Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello Team, hello Team,We are tryimg to register cisco 7841 ip phone in cme 10.0.but its not registering ,please check below configuration and correct ,configuration is attaching...voice register pool-type 7841 xml-config maxNumCalls 6 xml-config bu...
Hello everyone.We have a CP-7925G that has a problem of "infinite loop". When I turn it on, it keeps "resetting forever". Is there a procedure that can be done?Thanks in advance.
hi mates, i'd like to pull a report where i can see all of the button templates for my office, how do i do that with separating it from other offices? thanks mates
Hello,I'm looking for a proposal regarding the best design to integrated a full SIP IP Telephony for one site with an existing multisite H323 Cisco VoIP Network.Cisco architecture are based on multisite GK plateforme interconnected to a central DGK....
Hi All,Could you please help me to resolve this issue.Currently, our employee's extension information is populating in to the recording software in the DNIS column. We need for the actual DNIS to populate. CUCM Version: 9.1.2.11900UCCX Version: 9.0.2...
I am working on a system that has a H.323 gateway and when the caller is on a webex conference the call stops at exactly 1800 everytime they are on the call. I ran debug isdn q921, debug isdn 931, and debug voip ccapi inout. From the the data it seem...
All, on CM 8.6 I have made all the changes needed to have logs going to an external syslog server but the logs are not showing up. Are there any services I need to restart to put the change in effect? Thanks. Replies rated.
I wonder if anybody can help. I have set up CME with a SIP trunk. The system has a selection of wirless and wired H323 handsets as well as some 3rd party SIP endpoints. All the devices have registered on the system as well as the SIP Trunk. The issue...
Hi voice team, I will integrate via sip trunk a CUCM 8.6 with Microsoft Lync 2013, it can be configured so that the call with Cisco extension and appear in Lync that someone calling ? or if the person is using the Cisco extension appears in lync as ...
Hello There,I tried to go through some documents to understand how the licenses from 8.6 to 9.1.2 are calculated but to be honest with you found no answer for my question. Attached are 2 reports from 8.6 and 9.1. As you can see in 8.6 we had 1500 lic...
Question #1 I've had a voice mail pilot number working for a long time now. It's MS Unified Messaging (MS UM for short). Since we have more than one MS UM server, I thought I'd go ahead and create a SIP trunk for each of the MS UM servers and the...
Hi,I've CUCM 8.6 and all phones are registered on this server. I've installed new CUCM 10.5 version. On some phones I have manually changed tftp server to new cucm (one phones I set Alternate TFTP - YES). Cisco 6921 phones have no problem to register...
Hello,in an UCM 10.x environment with 7800 ip phones the user can add up to 99 speed dial destinations in User self portal. But just 6 of these 99 speed dial entries appears on the phone screen if the user press the navigation pad down.Where are the ...
Dears, I face a Problem related to Cisco 7821 IP Phone when I enabled Extension Mobility on the Phone and Create Device Profile that "Phone not Registered" appeared on the phone. can anyone face this problem and how to fix this.
