Fallback-DN Removal

[Will Castle]

I'm trying to remove/delete a fallback-dn in the VG450 Gateway. I was able to delete the DN manually within the CUCM, but when I view the stcapp supplementary-services, it's still being displayed. How do I remove/delete it from the stcapp supplementary-services, if that's possible. See attachment for what I'm wanting to delete.

[Carlo Poggiarelli]

Hi,

on VG config:

no stcapp supplementary-services

no port X/X/X

HTH

Regards

Carlo

[Will Castle]

This is what's happening when I input the commands...see attachment

[Carlo Poggiarelli]

Hi,

Please post your VG config

Thanks

Regards

Carlo

[Will Castle]

I'm still learning the Cisco CM, so please forgive me for asking how do I get that or get to that?

[Carlo Poggiarelli]

No worries Will,

On VG issue show run command 

Cheers

Carlo

[Roger Kallberg · Accepted solution]

stcapp supplementary-services
port 3/0/39
no fallback-dn

[Will Castle]

Merci Beaucoup Gents for the assistance. I was in the correct rabbit hole, but wrong tunnel. lol

[Will Castle]

Since I have you guys attention, quick question...can the time on the phone (Cisco 7841) be adjusted locally? It's currently 30 minutes ahead of the actual time.

[Roger Kallberg]

No. The phone gets it’s time from the CM.

[Maren Mahoney]

More specifically, the timezone listed in the Date/Time Group (assigned via Device Pool) will determine what time appears on a phone. If no DTG is specified, the phone will show the time in the CM Local (set during system installation).

Maren