cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

7000
Views
0
Helpful
2
Replies
Highlighted
Beginner

Getting Report of incomming and Outgoing calls in CUCM

Dear All;

I have CUCM 8.5, how can I get report of incomming and outgoing calls using CUCM.

Thanks in Advance ,

Rashed Wardi

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Engager

Getting Report of incomming and Outgoing calls in CUCM

Hi Rashed,

Please refer the below CUCM CDR guide,

http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucm/service/8_5_1/car/carustop.html#wp1033122

Table 5-5     Top N by Number of Calls Call Types 

Incoming

Inbound calls that originate outside the Cisco Unified  Communications  Manager network, enter through a gateway, and go into  the Cisco Unified  Communications Manager network.

On Net

Outgoing calls that originate on one Cisco Unified Communications   Manager network, go out through a trunk, and terminate on a different   Cisco Unified Communications Manager network. For CAR purposes, be aware   that any outgoing call can be classified as an On Net call if it is   configured as such in the CAR dial plan configuration window. See "Configuring the Dial Plan" section on page 29-2.

Hope it helps.

Anand

Please rate helpful posts by clicking on the stars below the right answers !!

2 REPLIES 2
Engager

Getting Report of incomming and Outgoing calls in CUCM

Hi Rashed,

Please refer the below CUCM CDR guide,

http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cucm/service/8_5_1/car/carustop.html#wp1033122

Table 5-5     Top N by Number of Calls Call Types 

Incoming

Inbound calls that originate outside the Cisco Unified  Communications  Manager network, enter through a gateway, and go into  the Cisco Unified  Communications Manager network.

On Net

Outgoing calls that originate on one Cisco Unified Communications   Manager network, go out through a trunk, and terminate on a different   Cisco Unified Communications Manager network. For CAR purposes, be aware   that any outgoing call can be classified as an On Net call if it is   configured as such in the CAR dial plan configuration window. See "Configuring the Dial Plan" section on page 29-2.

Hope it helps.

Anand

Please rate helpful posts by clicking on the stars below the right answers !!

Beginner

Getting Report of incomming and Outgoing calls in CUCM

Thank you Anada, I will try to implement this configuration ,

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards