06-21-2018 02:05 AM - edited 03-17-2019 01:03 PM
Hello,
I have Gateway VG01 with 2 PRI from ISP 1 and ISP2. Both these PRI are currently member of Trunk-Group PSTN. This gateway is defined as H323 on CUCM side, so there is no control on ports.
With current setup only 1 PRI trunk from ISP1 is in use (for outbound calls), since its a E1 trunk with 30 channels for call and not all channels are ever used so 2nd PRI never get hit.
Can someone suggest if we can change hunting withing trunk-group to load balance calls. I want hunting similar to circular algorithm in CUCM.
Thanks
Abhi
06-21-2018 05:45 AM
Hi there
You can create a RG with both H323 GWs, then use the distribution algorithm as Circular. Incoming you can talk to your Telco for load balancing between different PRIs.
Hope this helps!
Cheers
Rath!
***Please rate helpful posts***
06-21-2018 06:53 AM
06-21-2018 07:32 AM
I referenced CUCM hunting just for an example. I believe load balancing can be achieved by using trunk-group hunt scheme round-robin as per below Cisco documentation
06-21-2018 07:51 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide