ISDN PRI-GROUP E1

[Marcelo Bergamini]

Dear all!!

I have only one  E1 interface. I can configure this interface as ISDN and split it into two pri-groups? Similar to the DS0s of R2? Separating channels 1-15 and 17-30? Its possivel?

[Chris Deren · Accepted solution]

Yes, this has been asked many times and there are some very good recent threds on this topic.

Chris

[James Hawkins · Accepted solution]

Check out the thread below:

https://supportforums.cisco.com/thread/2114004

[Marcelo Bergamini]

Thanks all !!!