Good Day All,
I have configured a VG224 GW with CM4.2 and it does not seem to be registering.
The configurationis pretty stock/standard.
I double checked the host name with call manager and they match.
I have provided a copy of the router config minus passwords, aaa, line ports, etc and a copy of debug mgcp events.
If anyone has any ideas, they are much appreciated.
Solved! Go to Solution.
Yes... But what worked for you?
I am running CUCM 12.5
ISR4331 IOS 16.6.4
ISR IP@ coes up in CUCM... but trunk appears unregistered!!!
ISR4331 declared with full name hostname.domain
I have MFT-T1/E1-E1 HW
Pls help and tell me what was the solution for you
Sorry... But obviously all this been done
Double checked and everything
Looks like its a famous issue with Cisco:
CUCM sees my GW/Trunk unregistered ...but @ VoIP_GW(ISR4331) level, it looks fine =>
MGCP Domain Name: HUB2-VOIP-RTR.domainname
Priority Status Host
Primary Registered 33.1X.X.X
First Backup None
Second Backup None
MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE
MGCP call-agent: 33..X.X.X. 2427 Initial protocol service is MGCP 0.1
So everything looks OK @ this VoIP_GW level
But still, no E1 service! When I tried to call out, NOK
What I've been doing =>
- Reset GW & E1 Trunk @ CUCM level
- RIS rebooted @ Publisher + Sub/CallManager-role level (even Tomcat if i remember all I've done!)
- Reboot ISR4331
- Reboot mgcp(no mgcp / mgcp)@ ISR4331
- Break then rebuild mgcp setup @both level(CUCM + ISR4331)
So this looks very strange to me
Even if it's registered on ISR4331, the unregistered state @ CUCM level makes like unable to call out thru this E1, unable to seize that E1 trunk
THX for advice