MGCP gateway registeration issue

[sandeep pokhriyal]

hi,

MGCP gateway is showing " registering with CM" and it keeps on trying with CCM.

i checked the config also but in vain.

[Brandon Buffin]

Can you post your config as well as the domain name entered for your gateway in CCM config?

Brandon

[mattcalderon]

I agree with Brandon. your host name and domain name MUST match between the call manager and your gateway.

Link for Gateway config.

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf1.html#wp1027337

Check this link for troubleshooting gateway registration failures

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805a316c.shtml#prob

[sandeep pokhriyal]

hi,

thx for prompt reply.

the gateway name is same in callmanager and gateway. i tried removing domain also.

i am posting the config and debug of mgcp events.

[Brandon Buffin]

From "R01801.interior.gov.bh" in the debug, it appears that you have a domain name configured on the gateway. Be aware that this domain name must appear in the CCM config as well. You cannot simply use R01801.

Hope this helps.

Brandon

[sandeep pokhriyal]

ya i tried both adding and removing ip domain from router and CCM but still the same issue with other routers its working.. donno whts wrong with this one.

[mattcalderon]

After looking at your debug, you have verified that your gw name in ccm is R01801.interior.gov.bh ?

[mattcalderon]

just a bit quicker than I brandon, but essentially the same thing.

[sandeep pokhriyal]

ya i tried both adding and removing ip domain from router and CCM but still the same issue with other routers its working.. donno whts wrong with this one.

[Zin.Karzazi]

do a "no mgcp" then "mgcp" again, see if that could bring the GW to register.

please also post the "show ccm-manager" output.

[sandeep pokhriyal]

hi,

I am able to register the gateway.

i just registered one of the port of gateway on the callmanager and it worked like it should have...

thanks for all your contributions.