02-06-2014 01:47 AM - edited 03-16-2019 09:37 PM
Dear Colleagues,
I tried to implement hungarian locale onto our CME, with no success, I am working based on this guide: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmelocal.html
Unfortunately there is no user defined (U1-U5) option in the user-locale command, only the predefined ones (AT-US)
What am I missed?
Thanks,
Laszlo
Solved! Go to Solution.
02-06-2014 05:52 AM
Make sure you have configured "cnf-file perphone" and "cnf-file location flash:" under "telephony-service". After configuring these commands you should get U1-U5 option.
Regards,
Mohit Singh
02-06-2014 02:20 AM
Hi Laszlo,
Please refer below Localization matrix and see if you are meeting the requirement or not.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cmelocal.htm
Regards,
Nishant Savalia
02-06-2014 05:52 AM
Make sure you have configured "cnf-file perphone" and "cnf-file location flash:" under "telephony-service". After configuring these commands you should get U1-U5 option.
Regards,
Mohit Singh
02-06-2014 06:15 AM
Hi Mohit,
The cnf-file location flash command was the key... somehow I missed it.
Thanks,
Laszlo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide