05-14-2009 12:03 AM - edited 03-15-2019 06:00 PM
Hi Techie,
We are using 4 FXO port for connecting to PSTN. It is used for outgoing calls only. Till yesterday it was working fine. Since today morning its not working.We are using H323 3745 cisco gateway.
Configuration looks fine. We have taken ccapi debug log and gateway is matching correct dial peers and translation rules are also working fine. Gateway issending call setup request to remote telco. At this this time calls are getting disconnected. Cause Code is 0X22 which for No Circuit. It will grt if someone can help me with possible reasone behind this cause code.
05-14-2009 12:10 AM
If you disconnect the FXO from router and connect an analog phone r u able to get dial tone and dial?
can u post
debug vpm signal
debug ccapi ino
Thanks
05-14-2009 01:21 AM
05-15-2009 02:22 AM
Guys,
Please someone help me.
05-15-2009 04:49 AM
I took a look at the debugs. Without debug vpm signal it's pretty hard to tell what is going on. I can tell from the debugs that your IOS is pretty old. You can always try upgrading that to see if it helps.
-nick
05-21-2009 03:34 AM
05-21-2009 08:39 PM
Guys,
Please help me, suggest something.
05-21-2009 11:02 PM
.
05-21-2009 11:02 PM
Please configure
no supervisory disconnect signal
under all fxo voice-port.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide