01-19-2012 06:38 AM - edited 03-16-2019 09:06 AM
the registration seems to work properly and also all outgoing calls work the problem is with incoming calls from sip trunk. this is the config
voice service voip
no ip address trusted authenticate
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
h323
sip
bind control source-interface GigabitEthernet0/1.208
bind media source-interface GigabitEthernet0/1.208
registrar server
using this configuration sip to sip calls doesnt work i get a fast busy signals on internal calls. but incoming calls work
at the moment i remove the lines
bind control source-interface GigabitEthernet0/1.208
bind media source-interface GigabitEthernet0/1.208
the internal sip phones register but incoming calls wont work
im a bit confused
Solved! Go to Solution.
01-19-2012 02:25 PM
do you have an ip route to the sip trunk? make sure that you have!
see if the incoming digits are correct for you extensions, see if you need any translation rule.
Regards
01-19-2012 12:42 PM
Make sure the sip phone can reach the address of g0/1.208, and that is the soruce address used in "voice register global".
01-19-2012 02:25 PM
do you have an ip route to the sip trunk? make sure that you have!
see if the incoming digits are correct for you extensions, see if you need any translation rule.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide