Putting 9971 in Power Save mode in CME

[michaelngai]

Hi All,

Can't figure this one out for a while.  How do you put a SIP endpoint namely the 9971 into power save mode in a CME system (ie turn off the screen when not in use).

For a SCCP endpoint there are commands under "telephony-service" to do so, but these won't apply to a SIP endpoint.  There doesn't seemed to be equivalent commands under the SIP "voice register global".  Anyone has any ideas?

Thanks in advance for any tips and assistance.

[Karthik Sivaram · Accepted solution]

Hello ,

I think I answered a similar post before . Can you check this...

https://supportforums.cisco.com/message/4012873#4012873

Hope this helps!

Regards,

Karthik Sivaram

[michaelngai]

Yes that thread answered my question perfectly.  Thanks.