08-10-2013 07:36 PM - edited 03-16-2019 06:47 PM
Hi All,
Can't figure this one out for a while. How do you put a SIP endpoint namely the 9971 into power save mode in a CME system (ie turn off the screen when not in use).
For a SCCP endpoint there are commands under "telephony-service" to do so, but these won't apply to a SIP endpoint. There doesn't seemed to be equivalent commands under the SIP "voice register global". Anyone has any ideas?
Thanks in advance for any tips and assistance.
Solved! Go to Solution.
08-15-2013 08:00 AM
Hello ,
I think I answered a similar post before . Can you check this...
https://supportforums.cisco.com/message/4012873#4012873
Hope this helps!
Regards,
Karthik Sivaram
08-15-2013 08:00 AM
Hello ,
I think I answered a similar post before . Can you check this...
https://supportforums.cisco.com/message/4012873#4012873
Hope this helps!
Regards,
Karthik Sivaram
08-15-2013 03:42 PM
Yes that thread answered my question perfectly. Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide