Solved: Question about voice gateway

scottsassin · ‎06-13-2017

I haven't done voice in a while. Now I have been asked to replace some routers that we have in the field.

Do I need to order the voice bundle for the 4321 ISR, with a PVDM, if I'm only going to have one voip dial peer?

Thanks,

Scott

Chris Deren · ‎06-13-2017

If it has a dial-peer than means it's a Cisco voice GW or CUBE. Any version of IOS with proper UC license allows for building dial-peers, the key here is the UC license.

View solution in original post

Chris Deren · ‎06-13-2017

It depends on what the voice GW you are replacing is doing. If you can share "show run", "sh diagnostics", "sh inventory" we can provide further guidance.

scottsassin · ‎06-13-2017

Thanks Chris,

I am not replacing a voice gateway. I am replacing a branch router that has only one voip dial-peer.

What version of the IOS do I need for dial-peer?

Thanks,

Scott

Chris Deren · ‎06-13-2017

If it has a dial-peer than means it's a Cisco voice GW or CUBE. Any version of IOS with proper UC license allows for building dial-peers, the key here is the UC license.