SIP trunk configuration help

Deepak Kumar · ‎04-21-2019

Hi,

My VOIP engineer is on holiday and I stuck in a SIP trunk configuration. Please help me to complete SIP trunk configuration.

I have some doubt on VLAN ID which is given by the ISP. I am using Cisco 4431 as voice gateway.

Cisco router 4431.

Sorry I am posting through the mobile browser so ignore any typo.

Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!

HARIS_HUSSAIN · ‎04-21-2019

VLAN ID will not be used to configure SIP Trunk, So you can ignore the same

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

George Sotiropoulos · ‎04-22-2019

Hello,

The clarification of Vlan ID is not required for configuring a SIP trunk with the Provider. Do you need assistance on the 4331 CUBE configuration? You can find the following link (amogst others) useful:

https://ucpros.net/cube-configuration-part-1/

George

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies