IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

External calls are not redirected correctly

Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...

call forwarding.png
Translator by Community Manager
  • 1 replies
  • 0 Helpful votes

Resolved! ATA 186 Port 80 vulnerability

Hello Community!     Looking for a way to disable the web interface of these devices either from CUCM or local side. Our Security Dept has flagged these with a port 80 vulnerability and which our CUCM provider has yet to provide any reasonable action...

chadrife1 by Beginner
  • 9 replies
  • 0 Helpful votes

Resolved! Cisco 7961 IP phone showing blank screen after factory reset.

Hi Everyone,I have factory resetted my cisco 7961 ip phone firstly using 123456789*0# and then 3497672850*# ,but now its showing blank screen with all line buttons blinking in sequence.What happened to my ip phone ? is it dead ? how can I make my cis...

Unable to register in CME

Hello. I am mystified with my configuration. I have 7942 ip phone it is supported by my 2921 router with os version 15.2(M4). I was able to configured it successfully last week and it is working well. Since i dont have a full license for unified comm...

Resolved! NIM-2BRI-ST and ISR 4321

Hello , I have an ISR 4321 with 1 NIM-4FXSP and 1 NIM-2BRI S/T when i take a show inventory, the nim subslot are good Router#show inventoryNAME: "NIM subslot 0/1", DESCR: "NIM-4FXSP Voice Analog Module"PID: NIM-4FXSP         , VID: V01  , SN: FOC2232...

Resolved! Block Outgoing Calls based on the originating internal number/extension.

Hi All,   My query is, how is it possible to block calls to a specific outgoing number ( in my case it is  "2519 2519" ) , depending on who is initiating the call.    I have three different branch offices with different PRI ranges a each office .    ...

rahul nair by Beginner
  • 3 replies
  • 0 Helpful votes

Multiple day schedule with SNR

We have the following situation. 1 phone with 4 remote destinations (SNR) for our technicians with different work schedules. For 3 of them , is it a shift from 07:00 until 16:00 , so no problem. But for one is it from 04:00 - to 07:00 and then from 1...

koenvb by Beginner
  • 2 replies
  • 0 Helpful votes