06-19-2014 07:11 AM - edited 03-16-2019 11:09 PM
Hello,
Does anyone know the sip trunk config for Saudi Arabia.
we have bought SIP trunk from Local ISTP, can we get the configuration guide from ISTP.
what information will ISTP provide to us for the configuration of CUBE.
Any help will be highly appriciated.
Thanks,
06-19-2014 07:58 AM
Hi,
Usually the ISP provides the following:
Domain name
Password
User ID
DID ranges
Number of Sessions
SBC and CPE IP address
It depends on the provider, you'll need to check with them.
Regards,
Tere.
------
Please rate helpful posts.
06-19-2014 09:12 AM
06-19-2014 09:20 AM
you can also check these URLs.
http://www.cisco.com/image/gif/paws/99863/cube-config.pdf
https://supportforums.cisco.com/discussion/11955366/cisco-cube-configuration
12-29-2016 01:22 PM
Dear all
I have issues with stc sip line when i try to call from stc mobile call not response but when i try to from zain it is working perfectly
12-29-2016 03:15 PM
Hello,
Usually called number for calls originated from STC is appended with 011, while calls that originated from other ISP called number comes without 011.
Make sure incoming-called number/ destination number value are set properly on both incoming and outgoing dial-peers. I usually set it as: 0?1?1?44444XX, where 44444XX is an example range.
P.S. you can insert (?) by pressing ctrl+v then release keys and enter (?).
Thank you,
Shadi
Sent from my mobile
12-29-2016 03:46 PM
08-11-2014 08:22 AM
Hello,
were you able to configure your router, actually i am stuck with router configuration only.
i would appreciate if you can share your configuration file with me.
it would be a great help.
Thanks in Advance.
08-11-2014 09:03 AM
Hello Mehaomed
Are you going to do integration with STC ?. For me i did many integration on KSA with STC all over KSA .
Thanks
please rate all useful information
08-11-2014 11:51 PM
Hi Islam,
Actually i m new to it with no prior experience, i would request you to share any running configuration file for cisco 2900 series router. i received configuration from stc:
Thanks in Advance.
08-11-2014 11:51 PM
Hello
sure , i will provide you with a perfect configuration which already tested . I have only on question , did STC share with you any infformation about VLAN id to created?. just a question.
Thanks
please rate all useful information
08-11-2014 11:53 PM
no the above mentioned configuration is the only thing i received from STC no vlan ID.
06-06-2015 03:07 AM
Hi All,
I have a similar situation with STC and no proper response from STC to troubleshoot. Was this issue resolved? I managed to get calls bothways but once AA transfers, the calls gets disconnected :(
Sam.
08-12-2014 03:59 AM
Mohamed
As per your DID 133459300-133459499, you have to use range from 9XXX. because your range of your DID ends with 9XXX. If you use 3XX , you will lose the other range which starts with 4XX.
Thanks
please rate all useful information
08-12-2014 05:26 AM
please explain where do i have to use this range? in router or in cucm.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide