cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
997
Views
0
Helpful
7
Replies
Highlighted
Beginner

Softkeys not working on IP phones

Hi

I will appreciate support for a situation I have encountered for one customer.

The server hardware is MCS 7825. A total of upto 600 IP phones registered. I noticed that the conference bridge is registered on the subsriber.

Client have 1 Publisher & 1 Subscriber. Th  CUCM version is 6.

When a call is received from a telco line/mobile, end user answers calls but cannot transfer or take another party in a conference call as the softkeys are non functional. This is not the case for extension to extension communication. Also when i naviagte within the cucm gui, i noticed a delay to navigate between pages.

Thanks

Ibrahim SAYEED

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Master

Softkeys not working on IP phones

Make sure the Gateway configuration in CUCM does not have "require MTP" checked.

HTH,

Chris

7 REPLIES 7
Hall of Fame Master

Softkeys not working on IP phones

Make sure the Gateway configuration in CUCM does not have "require MTP" checked.

HTH,

Chris

Beginner

Softkeys not working on IP phones

Hi Chris

Thanks for the suggestion. I will check and confirm on that.

Beginner

Softkeys not working on IP phones

Yes 'MTP Required option" was checked. The issue got resolved when i unchecked the option. Thanks Chris.

Softkeys not working on IP phones

Hi Chris and Ibrahim,

We are experiencing the same problem. We found this thread and looked on the gateway but we don't see the option "MTP Required".  Where exactly did you find it?

Thanks in advance for your help and time,

Vince

Hall of Fame Master

Re: Softkeys not working on IP phones

The gateway definition on call manager, upper portion of it.

Chris

Sent from Cisco Technical Support iPhone App

Re: Softkeys not working on IP phones

Thanks for your quick response Chris, I appreciate it.  I should've mentioned that the gateway in question is MGCP not H.323.  I don't see that option in the MGCP gateway configuration screens. 

Hall of Fame Master

Re: Softkeys not working on IP phones

It is under the specific trunk, i.e. PRI under the MGCP GW drill down to the port.

Chris

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards