we're using CUCM V 11.5.1.12900-2. i'am trying to activate SSH connection on an IP phone which is done because i can now try to log with Putty and it is asking for a user/password.
In CUCM in device > Phone I did change the Secure Shell Information (user and password) but it lookslike the phone won't update with this configuration or it won't accept connection even if the SSH access is enabled.
I am not sure if you could do that through the CLI. The shell is restricted to phone debugs AFAIK. Root access might be possible but not for customers.
Nipun Singh Raghav "We cannot solve our problems with the same thinking we used when we created them"
since we got alot of different sites. we wanted to see if we could reset phones with command line and use the auto-registration without having someone onsite doing this.
when i mean auto-registration i mean when you dial 70100 + DN + #
Phone shell is for debugging purposes primarily. Root should be confined to DE or TAC access only. If you need to reset remotely, bounce the switch ports.
Nipun Singh Raghav "We cannot solve our problems with the same thinking we used when we created them"
I am not sure if you could do that through the CLI. The shell is restricted to phone debugs AFAIK. Root access might be possible but not for customers.
Nipun Singh Raghav "We cannot solve our problems with the same thinking we used when we created them"
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
