Updating MGCP Router/Gateway in CUCM

[Mark VandeVere]

I may have searched in all the wrong ways, but am not finding anything that matches

We just replaced 10 28XX gateways with 29XX gateways. They all run MGCP. While they all work under their prior CUCM configuration with the 28XX model shown, I'd like to keep all that up to date.

Is there a way to make a change to the router model without building a new one and deleting the old one, or is this it for me?

[Jaime Valencia · Accepted solution]

No way to change the model, you need to recreate them using the new ISR G2 model.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

[Mark VandeVere]

I was pretty sure that I hadn't missed anything, but was hoping Thanks!!

[Nishant Savalia]

Hi Mark,

Please check below link, might be helpful to you.

https://supportforums.cisco.com/docs/DOC-33875

Regards,

Nishant Savalia