cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
588
Views
0
Helpful
3
Replies

Updating MGCP Router/Gateway in CUCM

Mark VandeVere
Level 1
Level 1

I may have searched in all the wrong ways, but am not finding anything that matches

We just replaced 10 28XX gateways with 29XX gateways. They all run MGCP. While they all work under their prior CUCM configuration with the 28XX model shown, I'd like to keep all that up to date.

Is there a way to make a change to the router model without building a new one and deleting the old one, or is this it for me?

1 Accepted Solution

Accepted Solutions

Jaime Valencia
Cisco Employee
Cisco Employee

No way to change the model, you need to recreate them using the new ISR G2 model.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

3 Replies 3

Jaime Valencia
Cisco Employee
Cisco Employee

No way to change the model, you need to recreate them using the new ISR G2 model.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

I was pretty sure that I hadn't missed anything, but was hoping Thanks!!

Hi Mark,

Please check below link, might be helpful to you.

https://supportforums.cisco.com/docs/DOC-33875

Regards,

Nishant Savalia

Regards, Nishant Savalia
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: