12-11-2019 11:03 PM
Hello,
We have a CME 10.5 (Cisco 2921, IOS 15.4(3)M6a), and couple of VG204. As we could not register more phone to the CME, we configured the VG204 with dial-peers for call routing. Inbound, outbound calls are fine except the caller ID:
For calls from IP phones registered with CME to analog phones connected to VG204: the caller (IP Phone) doesnot see the called party name (only see number), we have configured caller-ID name on VG204 voice ports.
Here is the configuration:
VG204:
!
voice-port 0/0
cptone IN
station-id name Amit Bhati
station-id number 7748
caller-id enable
caller-id alerting line-reversal
!
dial-peer voice 8000 voip
description ** Intra-site **
destination-pattern ^7[78]..$
session protocol sipv2
session target ipv4:172.23.4.10
incoming called-number .
voice-class codec 1
dtmf-relay rtp-nte
no vad
!
dial-peer voice 8020 pots
description Amit Bhati
destination-pattern ^7748$
port 0/0
!
CME router:
!
dial-peer voice 8020 voip
corlist incoming National
corlist outgoing Internal
description Amit Bhati - VG204_2
answer-address ^7748$
destination-pattern ^7748$
session protocol sipv2
session target ipv4:172.23.4.14
voice-class codec 1
dtmf-relay rtp-nte
no vad
!
Could someone give me some suggestions on how to enable called party display name for this setup?
Thanks,
hoanghiep
12-13-2019 08:11 AM
Hi,
Which phone models are you using to dial VG204? Also, do you have SIP or SCCP CME configured?
12-15-2019 10:28 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide