VG204 - caller name not working

[hoanghiep]

Hello,

We have a CME 10.5 (Cisco 2921, IOS 15.4(3)M6a), and couple of VG204. As we could not register more phone to the CME, we configured the VG204 with dial-peers for call routing. Inbound, outbound calls are fine except the caller ID:

For calls from IP phones registered with CME to analog phones connected to VG204: the caller (IP Phone) doesnot see the called party name (only see number), we have configured caller-ID name on VG204 voice ports.

Here is the configuration:

VG204:

!

voice-port 0/0
cptone IN
station-id name Amit Bhati
station-id number 7748
caller-id enable
caller-id alerting line-reversal

!

dial-peer voice 8000 voip
description ** Intra-site **
destination-pattern ^7[78]..$
session protocol sipv2
session target ipv4:172.23.4.10
incoming called-number .
voice-class codec 1
dtmf-relay rtp-nte
no vad
!

dial-peer voice 8020 pots
description Amit Bhati
destination-pattern ^7748$
port 0/0
!

CME router:

!
dial-peer voice 8020 voip
corlist incoming National
corlist outgoing Internal
description Amit Bhati - VG204_2
answer-address ^7748$
destination-pattern ^7748$
session protocol sipv2
session target ipv4:172.23.4.14
voice-class codec 1
dtmf-relay rtp-nte
no vad
!

Could someone give me some suggestions on how to enable called party display name for this setup?

Thanks,

hoanghiep

[Vaijanath Sonvane]

Hi,

Which phone models are you using to dial VG204? Also, do you have SIP or SCCP CME configured?

[ashok_boin]

Hi, This should be working as expected with DTMF Standard in which only Number in Caller ID is supported. Pls look at the following link... https://www.cisco.com/en/US/docs/ios/12_3t/voice/command/reference/vrht_s12_ps5207_TSD_Products_Command_Reference_Chapter.html#wp1146782 Have you checked through "debug voip ccapi inout"? Regards... Ashok.