04-02-2008 09:56 AM - edited 03-15-2019 09:48 AM
Trying to get a VG224 registered to UCM 6.0 but it is not registering. I noticed in the vg224 sccp setup, you can put a CCM version in there (but only up to 4.1). Is VG224 SCCP setup supported with UCM6.0?
I only need to fun analog phones off of this.
Regards,
04-02-2008 10:56 AM
Im almost 100% sure that VG224 isnt supported in call manager 6.0 only Vg248 is supported.
HTH
Matt
04-02-2008 12:02 PM
is there any docs to this? links?
04-02-2008 12:21 PM
i found a SRND for UC 6.x and as an endpoint they specify the VG 224. This would indicate that they do support it.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/6x/endpnts.html#wp1044041
04-02-2008 12:29 PM
fair enought but i was fairly certain that the 6608 module and the vg224 were no longer supported. I will try get some confirmation.
Are you running 12.4T image?
04-02-2008 12:34 PM
Hi Daniel,
I have worked with people who are successfully using the VG224 with CCM 6.0 so I don't think that is the issue :)
Here is a post from Adam;
I am not an expert with the VG224 as we are using all VG248's but there are some excellent config steps shown in this doc;
http://www.cisco.com/en/US/customer/docs/ios/12_4t/12_4t2/ht1vg224.html
Hope this helps!
Rob
PS: I think the VG248's (like we are using :( are being phased out in favour of the VG224's.
04-02-2008 12:53 PM
my bad it must have been the vg200 i was thinking about. Sorry about that.
Matt
04-02-2008 02:05 PM
Hey Matt,
Every time I turn around one of the products we use is going EOL :) Who knows from day to day (I think we need to get on the EOL Mailer).
Take care,
Rob
04-03-2008 03:32 AM
Thanks Rob and everyone for your replies. I could not get VG224 when I setup as SCCP, so I switched it to MGCP. It registered right away.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide