Network Access Control

Cisco Access Control Server (ACS), Identity Services Engine (ISE), Zero Trust Workplace
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

Labels

Forum Posts

We have a Cisco Access Control Server (TACACS+ version 5.1) with an additional 2 port NIC card. This produces 4 ports on the ACS server(G0 through G3).After initial setup of the ACS server with an IP address on G0, I connected a Windows 7server with ...

hufa97 by Level 1
  • 7548 Views
  • 8 replies
  • 0 Helpful votes

Recently our headquarter upgraded our ACS server from version 4.2 to 5.2 with a new IP and system. I am updating the new tacacs-server host IP and key to my local switches. When I typed in the command : tacacs-server host x.x.x.x key xxxxx , the swit...

I could not SSH to ACS SE appliance? Any idea why I could not, however I can do on another ACS SE.Please note that I can ping the ACS SE, after disabling the CSA, so netowrk connectivity is ok.Cisco Secure ACS: 4.2.0.124.Thanks and Regards,

I got problem with testing 802.1x MDA. The AUTH-MGR notified me with weird error messages.*Mar  1 06:41:05.610: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/13, changed state to up*Mar  1 06:41:17.470: %AUTHMGR-5-START: Starting 'mab' for client (a8b...

I am new with ACS server 5.2 can someone please help me before I bang my head on the wall. I have configured the ACS server 5.2 but still cannot authenticate users. The router can ping the ACS server. With debugging I got the following error message:...

isoyewale by Level 1
  • 1054 Views
  • 1 replies
  • 0 Helpful votes