Network Access Control

Hello Dears,I have created a user in ACS 5.0 i want to give piriviledge level 15 to that user,which TAB i have to route to give permission of privilege 15,i have worked on ACS 4.2 ,,ACS 5.0 is very much new for me

Hi,I have set-up with below devices :Wireless LAN controller 5508LAP 3302iand ACS 5.1 since i am new in ACS 5.1 configuration , I need so information to go ahead to configure ACS 5.1.which EAP method to use for wireless client authentication ? what i...

Hi,I want to configure ACS 5.1 with PEAP eap method and AD database replication or if  somebody recommands other eap method than peap which is  less complex and secure , it would be great help.how to go about ?I want to configure one ssid with mentio...

Hi,I have acs 5.1 installed on ACS 1121 hardware appliance. Now i want to get external data from AD replicated in ACS box. how to configure ACS to get replicated user database?what else I need to get details from windows administrator for AD replicat...

Hi,I have a switch 3650 with the IP base image IOS 12.2(25) SEE3, a polycom phone SoundPoint IP 430 SIP, A radius server IAS 2003 and a Windows XP PC.I enabled the windows XP pc for wired authentication ( started the service Wired AutoConfig, added t...

I have a 3725 that was using tacacs for auth but that is not working with our new ACS 5.1 server so for simplicity I would like to switch to radius. The authentications pass but the dial in user gets error 738 "didn't assign an address" My auth on th...

First the background - we have four ACS5.1 appliances (all at patch revison 4), Box1 is the management box - so just used for accessing the web interface and setting stuff up, boxes 2 and 3 do the main bulk of the work and box 4 is basically a spare....

Hi,I have PEAP-MSCHAPv2 working with user name, but can't seem to get "machine authentication only" working. I need to logon to the domain using username and password before it is 802.1x authenticated. I want 802.1x to authenticate using only machine...

Hello,I am about to implementing dot1x in our LAN. I understood that I have to use multi-domain mode to get this work well ifI use ip phones and PCs attached after the phones.I have Avaya 4600 phones which only supports EAP-MD5 authentication.In Avay...

I know this has been asked in a few different ways but I need to clarify the user experience under the following configurationMy ASA uses ACS4.2 as a radius server and it also provides downloaded ACLs depending on the users group within LDAPOur Secur...