Network Access Control

We have devices which use ACS as AAA. On most of the devices, there is a need to put the login/password multiple times( around 2 to 3) before it successfully allows to login.If the logins are again followed up within a very short duration it sometime...

Hi all,Currently ACS 5.0 doesn't support all the features provided by ACS 4.2. In particular, do you know when ACS 5.0 will (fully) support RSA SecurID authentication ? Regards!

I am configuring ACS 5.0 and have some problem which I do not understand.I have 3 policy created to access Cisco routers and switches.I am trying to have authentication run trhough the AD then local DB if user not found in AD or AD not available.I bu...

Guys we have acs 4.2 installed ...as it was a single point of failure we have another server now running as a redundant server in a datacentre....all the configs has been done already but the authentication is not been done the server is getting repl...

Hi,we're using ACS v4.2 for MAB and vlan-assignment. We imported the user's (mac-addresses) to the internal database via "CSUtil". The solution is working very well, the process for adding new mac-addresses is running . The process for deleting „ol...

please, I am configuring a 10000 and I need to add "Acct-Input-Gigawords" and "Acct-Output-Gigawords" in the accounting register. How can I configure that ?Thanks in advance !Cleber

At the moment I'm evaluating ACS 5.0.0.21 (Eval-Version).I defined a Service Selection that leads to an Access Service named "DeviceAdmin".Within this I defined Authorization Rules (Standard Policy) with Conditions an Identity Group and/or UserName.T...

I want to setup my ACS appliance to where my admins logon to it with their Active Directory accounts instead of using the Admin id. That way they can review reporting etc. Your help is appreciated.

hi, I would appreciate to receive some configuration steps on ACS to fulfill the following requirement and hope you can help me.ACS GroupsNetadmin - need telnet/ssh/vpn/wirelesswireless - only wireless authenticationvpn - only vpn authenticaitonI nee...

I have been using the ACS server as a tacacs host on the switch. The ACS server is allowing me to add an Active Directory group to an ACS group, and when you login you get privilege level 15 but with a restricted command set. You can see who entered ...

Hi,Cisco router trying VPN authentcatoin via windows 2008 NPS RADIUS server but "Access-Reject" by NPS.1. windows 2008 NAP1) radius clients-address=10.10.10.1 (router IP address)-vendor name=radius stanadard-sharded key=manual-key=123452) netrork pol...