Network Access Control

is there a way to configure per user QoS Policy in ASA?I need this because to configure ssl vpn users to have different bandwidth

require information on the different access level and the roles for each of level of access

I have a windows 2003 server with AD and IAS configured. IAS uses AD for authentication. I have AAA login configured and working. I have AAA dot1x configured on the 3550 switch. IAS has a Wired Ethernet policy configured for PEAM and is send back att...

hayI want to ask you friend I have AD window 2K3 service pack 1 and ACS 4.2 i think it is well to configure i can import all groupe window and the mapping but anyone user is not able to authenticates itself.1)I believe that I need an agent?if yes gi...

I have 2 fresh out of the box Windows 2003 Servers/SP2 on Sun Platforms that I have installed 4.1.1.24 and then upgraded to 4.1.4.13.Once installed and I finish the installation I have the service start and the Admin interface come up in a browser.I ...

Greetings,I am attempting to set up a 2800 series router for dial up access. I would be using Windows XP to set up a connection, via the modem, to the router. I am able to reach the router and begin handshaking but when it goes to authenticate my u...

HiI have introduced the following configuration of AAA in the switches of series 2950 and works very well, but when I do the same in switches 2960, the local password does not work and it is obligatory to introduce the switch in the ACS to have manag...

Hi All...Below is the configuration i had done onto the switch for AAA.aaa new-modelaaa group server tacacs+ tacgroup server 172.30.xx.xx server 172.30.yy.yy!aaa authentication login default group tacgroup enableaaa authentication enable default gro...

Hi,To aviod our network engineers enter router config mode by accident, we are looking for a way to let ACS server re-authenticate (popup a username & password prompt)users when they enter "configure terminal" command...Can you guys help me out ?Than...

Dears Experts,I have 2 ACS SE Appliance (4.2) and need to Integrate with Windows AD for Wireless User Authentication. I found lots of documents, but discusses about the ACS for Windows and its integration with AD but, i coudnt locate any document for...

HiI am using ACS 4.1 for W2K and i have some problems to purge logged in users. Whe i want to do this action the message "No users at IP x.x.x.x" appears. Until now i have about 300 users which i can't remove from the "Logged-in Users" list. I didn't...

Hi,I'm upgrading some systems from ACS 4.1 to 4.2. The first three went fine. On the third the install aborts. I get an error message "Setup failed to export your old user database" and then "Setup could not backup your old configuration. Please ...

Ran recovery disc 3.3 to wipe out ACS for re-deployment into another network and all I get now is "CMOS Checksum BadPress F1 to Run SETUPPress F2 to load default values and continue". Needless to say, F1, F2 have no effect. Any ideas?