Network Access Control

We have a new ACSSE-1113 that won't boot to the login prompt... the screen just stays black. We see the POST info as the SE first starts up, but it never gets to the login prompt.Any ideas would be appreciated.Thanks.John

I have a large number of switches which need to be inputted into a network device group, to save time, does anyone know of a way to bulk import these devices?

When I shutdown the primary ACS service, the authentication and accounting take a long time to process. Is it normal? Whenever new command is enter, it take sometime to display after the command authorization. The time toke almost the same as timeout...

HiI've got a CSACS 4.0 server and a number of IOS routers all configured for aaa to that CSACS server and the way I've got these routers configured, it is possible to login direct to the privileged exec mode (no need to enter 'enable' and another pas...

Hi, 2 questions about AAA authentication since i'm quite confused with the available documentation and currently i have no devices available to test :1) when "aaa new model" entered does login authentication immediately applies to all lines and defau...

Hi, I configured the router to authorize all copy commands. Under ACS I need to allow only copy run: start: and Copy run scp: When I added under urguments: permit run: startup: permit run: scp:it works fine for first one but for scp it will not.When ...

HI,Can anyone guide me how to configure windows authentication & authentication server in multidomain scinario?Actually I have two domains.Different user roles should be authenticated by different domains.Once the user is authenticated by a domain he...

Hi AllI need your help. I have to configure the ACS Server so that the network administrators can use their windows/Domain accounts to login to the network switches and routers. I have created 2 groups, one is the general and the other one is for net...

I have most of my customers Network Devices set to use tacacs+ thru an ACS server to authenticate Remote Admins whom ssh to these devices.I was attempting to set up a cryptic password as the authentication means for Console access to any of the devic...

Tacacs authentication doesn't work after passing thru GRE tunnel with Crypto map.

Dear AllI have a query regarding Cisco Remote VPN Users who are connecting to ASA box where i have created VPN groups (and IP Pool)and ACL are created and assigned to those groups .However for authentication , i have configured that group for TACACS ...

Hi all ,This is my first post.I am a newbie in this feild with a vague idea about EAP.I wanted to understand the EAP authentication process.Let me explain EAp in a way in which I understand.Please correct me or suggest some docs which I should refer ...

nac 802.1x, CSA in test mode, trust agent 2.103, CSSC 5.0.2.3At implantation nac 802.1x there were following problems:Some computers after passing machine authentification long cannot receive ip address (about 3 minutes) and Windows roaming profile d...

I have problems with same topology over ACS. I have two domains in diferent Active Directory, we map those domains. Then in the Active Directory we create two groups for both domains. One for users names and passwords and another wich contains the PC...