Network Access Control

Hi All,Does any one know how can I modify the Login Page appearence of ACS 4.1. I want to add my company logo along with Cisco on login screen. Thanks

I am getting this message on the ACS 4.1 server failed authentications log.The strange point is that i get thme only for a specific timeframe and then they stop.I am using PEAP-GTC as the authentication method with 1242ABG APs and Intermec CK31 clien...

HiI need an ACS box to return IETF RADIUS attributes 135 & 136 to a NAS for the assignment of DNS servers to clients.The ACS 3.3 user guide lists these as supported IETF RADIUS Attributes however they don't seem to be available under Interface Config...

Hi all,Two factor authnetication is considered be any two of the following.1) Something you know2) Something you have3) Something you areI want to know whether any of you would consider the following as two factor authentication...A preconfigured cop...

Hi everyone,I would like to know which SNMP MIB is effective to the operation monitor for Cisco Secure ACS SE. And which SNMP MIB I should monitor by SNMP such as CPU utilization, memory utilization and so on, on Cisco Secure ACS SE. However I can no...

Dear Sir,I have isntalled cacti (latest version) and it is working fine. When i add AS5300 in devices, It was also fine for graph showing about CPU usage, I want to show in graph that how many users are connected, average users and maximum users on A...

Hi Everyone,I have the below working config for TACACS+ authentication and accounting for IOS based devices. Would anybody be able to give me a CATOS version for the config?Many thanks,Danaaa new-modelaaa authentication login default group tacacs+ lo...

Hi,Mistake occurred while configuring 1811 in the remote branch. I' was not in time to add line ?username ?. privilege 15 secret ...? to Cisco config.I?ve executed ?wr mem? and connection was dropped.I?ve configured only enable secret 5 ... andip rad...

We have established a site-to-site VPN tunnel, but we are struggling with RADIUS setup. Problem is that two sides of tunnel use different vendor products. Our service provider uses Juniper's Steel Belted RADIUS, while we use Cisco ACS RADIUS. I assum...

Hi All,I am trying to create a series of group mapping between a single Windows group and a single ACS group. I am using a 4.1 ACS Appliance with a Windows ACS Remote Agent on a AD installed. I can add the database successfully and map to the domain....