Network Access Control

Hi,I am trying to get a dialup config to work that uses virtual profiles by virtual template and AAA configuration. When I follow the Config guides (12.2 in my case) I am told to use the command virtual-profile aaa. This command does not seem to exis...

I have setup our AUX ports on our routers so that it uses a local username and password for authentication and authorization, instead of the TACACS that the other lines use. It works ok, but it still prompts me to enter an enable password to get into...

Hi there,message description says it all, really. Is there a way to prompt users who wish web access for a username and password from a local authentication database stored on the PIX? I am aware that this can be done using aaa to a RADIUS or TACACS+...

Hi,I'd like to be able run aaa on the secure part of my network, and I came across an article on Local AAA server (IOS Security Confiruration Guide, Release 12.4) that say I should be able to do just that..I have a 2600 with c2600-ipbasek9-mz.124-8I ...

Ihave two queries , when APSEC AH Protocol used IP Packet is expanded/added during simole VPN session two modesHow much Ip Packet is expanded/added1. IP Packet expanded in transport mode2. IP Packet expanded in tunnel mode

Dear Alli have Cisco Secure ACS solution engine with v3.3, and i want to add external database to it ( Active directory ) i tryed many way and i follow the Dc but unfortunaly it didnt adddany body could help me step by step and he port i ahve to conf...

When ISAKMP begins in ike phase 1 to look for an ISAKMP policy that is same on both peers. I have two queries1. Which peer will send all their policies to match?2. Which peer will try to find a match? calling peer,called peer, in both cases

My query is that who much IP Pachet isadded/expanded in following two case.1. ESP IN TRANSPORT MODE.2. ESP IN TUNNEL MODE

HI I have a problem with my configuration. can someone help.I have a freeradius, pix and vpn client and i install the radius to authenticate the vpn users. i tested the authentication from the pix to the radius OK but if I want the vpn user to authen...

Hi everyone!Equipments involved:Cisco ACS 3.3 ApplianceMicrosoft Active DirectoryAironet 1200 APIBM Thinkpad T42, WinXP SP2Authentication used:WPA/TKIP/PEAPSupplicants:Thinkvantage (4.12)Odyssey Client 4.32Windows PEAP SupplicantProblem:How to push n...

Hi,I have recently implemented ACS 4.0 for autentication of remote access users. Our helpdesk have found a slightly niggly issue that I am wondering if anyone knows how rectify.Issue below:-A user is created in ACS who is authenticating against the A...

HelloDoes anyone know if there is any effect when Cisco ACS service pack is upgraded for version 2 to 4 on windows 2000.This is especially if users authenticates through Active Directory

I try to establish a link to an external database by LDAP SSLI put all information in the common LDAP configuration, I set the port to 636, Checkmark are on LDAPv3 and Use SecureAuthentificationI put the path of my .db fileBut when I try to map ACS g...