Network Management

Hello,we are using LMS 2.5 (CS 3.0.3, CM 4.0.3, RME 4.0.3). The config archival status of cisco catalyst blade switches 3020 for hp is failed with errors:CM0056 Config fetch failed for c302001xxxx Cause: CM0204 Could not create DeviceContext for 525 ...

Hi all,I installed LMS 3.0.1 on ESX server. The instalation directory is E:/CSCOpx. When I tried to access this LMS server on the URL http://name:1741 the access page appeared - I use name admin and password and then click Login. After this clicking ...

One question?, This device cisco 4400 series, wireless lan controler MODEL 4402 is support for the LMS 3.0?, because Do not Find the file lms_3.0_supported_devices.pdf.However for LMS 2.6 if this.Thanks.

Can't seem to find anything on the following SNMP traps sent from our ONS node. Can anyone help shed some light on these?1.3.6.1.4.1.3607.6.10.30.0.5100 1.3.6.1.4.1.3607.6.10.30.0.5120

Running Dec update on Windows and tomcat is using all the cpu. Haven't tried stopping starting the dmgtd yet. Is there anything I should investigate first? thanks

Hi All,I upgraded to LMS 3.1 onto a new server this past weekend.Here are the steps I followed:Step 1. Back up data from old server which as LMS 3.0 300 device license installed.Step 2. Shut down old Server and install new server install LMS 3.1 with...

Hello All,I have recently upgraded my RME to 4.0.11. I have 2 problems. On one of my servers the Software Center is showing my current version of RME to be 4.0.11 after the upgrade, however when you go to the RME homepage it displays 4.0.0 at the t...

Hi. I am using cisco asa5510 for my office network.My remote sql server which is outside my office network has problem replicating sql traffic to my sql server sitting in my office network. I have already allowed the public ip of my remote sql server...

I guess the big question is can it be done. I'm not a guru so I'll try to explain the best I can...We have a network of distant terminals with two hubs. For some reason it was decided not to place a tunnel between the two hubs so there isn't connec...

Good dayI am struggling to improve the voice quality over a point to point link. I have 2 asterisk servers which are connected with a 256k link between office A and B. The moment when the line gets busy the voice quality gets very bad.I enabled ip he...

Is there anywhere where I can find what MIB number means what?I am getting this information from our switch and don't know what I should look at....I checked the switch via show tech and did not see anything wrongMIB for this device, a 6 is "enterpri...

Just upgraded from LMS 3.0.1 to 3.1 and there is a problem with RME 4.2.0 and CM 5.1.0 picking up new devices. New devices are being picked up correctly in device discovery and being added to DCR (although it does seem to take a while after discovery...