Cisco Prime Infrastructure user account creation

[lucipher]

Hello everyone,

We have CPI version 3.1 installed on VM and the OS is RHEL. My question is, is there any way to create a user account in CPI through OS command line? I know it can be done via GUI but I want to know if it possible to do it via command line.

Any help is appreciated.

[balaji.bandi]

Good question : after intial setup, never thought go in to command level and play, other than some clean up

in the document it says : (not tried, check)

username

Adds a user to the system with a password and a privilege level.

[marce1000]

 - Start by going into configuration mode and enter the username directive, append it with ? to discover further command options sequentially as more parameters are being entered.

M.

[lucipher]

Hi @marce1000,

Pardon me as I am a newbie to this field. Can you tell me or provide me any link as to how to enter into the configuration mode?

[balaji.bandi]

here is the good guide how to access command level :

https://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1-2/command/reference/cli12/cli12_chapter_00.html

[lucipher]

Hi @balaji.bandi,

Actually I want to create a user account without taking ssh...So, is there any way which will enable me to create an account in CPI from the OS? Is there a fallback mechanism for CPI at OS level?

[balaji.bandi]

what kind of OS we are considering here ? Prime itself build on top of OS and it has user creation from command level which is for PI.

[lucipher]

I am talking about Red Hat OS which comes packaged with CPI. I have root access to Red Hat. From there, I want to add a new user in CPI.