Hello Everyone,I want to test my medical device which connects to the cloud sever through LAN and currently through our office lab network. I want to perform test by simulating the hospital network for various Downlink/Uplink speeds, latency, jitter ...
Forum Posts
Hello So currently I have a DSL MODEM - FPR1010 - SG350XG. My Internet is DSL w/ 8 static IP's and the FPR does the PPPoE and is connected to the SG350XG with routing back towards the Internet... On the SG350XG I have 6 vlans [each single vlan is a...
Hello everyone, I would like to secure my router using Netconf with an access-list. Documentation says: netconf-yang ssh {{ipv4 | ipv6 }access-list name access-list-name} | port port-number} But on my router there is no such option: router#netconf-ya...
Hi all,there is a problem that we try to solve since some days.On an WLC 5520 with a management IP-address say 10.0.0.1 I can access the GUI from network A (172.16.0.0/24) but not from network B (10.3.0.0/24).From both networks A and B I can ping the...
how to get the OEM letter. kindly help with this.
I'm trying to find a regular expression that works with a show command (such as show ip bgp summary) and only displays the IP addresses in the output, excluding all the other characters. I came up with the following:show ip bgp summary | include ^[0-...
Hi Team.Currently, in EPNM8.1.1 version, after configuring the EPL service for NCS5504 and ASR903 equipment, a failure occurs when looking up LSP OAM. I am wondering if this is a problem with the software XR and XE versions or if it is supported.NCS5...
Hi,I'm trying to do this exercise, i've already configured the ips , the dhcp server and the ssh to the switchI still not find the way to implement the NAT on the gateway, can someone help to configure that?I give you the exercise to help me better.T...
Dears, I have a customer who has an issue with voice between two branches; the WAN link is utilized at peak hours of the day. I need a full QOS conf end-to-end from the access switch to the WAN router Does anyone have a document ...
Resolved! Rx power low warning in cisco 2960Cx
I am getting below error in cisco 2960cx switch and switch is showing not online.
Is there anyway I can get email alerts for BGP events especially when an adjacency goes down? I need help configuring it using either EEM or Cisco Prime.
This is after deleting the previously stored key from/home/myid/.ssh/known_hosts.debug1: sending SSH2_MSG_KEXDH_INITdebug1: expecting SSH2_MSG_KEXDH_REPLYdebug3: check_host_in_hostfile: filename /home/myid/.ssh/known_hostsdebug3: check_host_in_hostfi...
Hi.We have remote location with ASA and in datacenter we have Palo Alto with internet break out.I might be dumb but, how do I configure the ASA to have whole traffic being sent through the tunnel?How should the routing be configured on ASA? ... and c...
Resolved! Cisco Prime 3.2 credential issue - SSH
Error: Could not connect to device via CLI (SSH/telnet). Check device credentials and SSH/telnet reach-ability.Getting error when trying to connect or add devices to Cisco Prime. We have created new credentials profile but prime fails to connect to d...
Hello,I am looking for a NetFlow analyzer that can display and report statistics using the Post-NAT Destination IPv4 Address.For example, I’d like to monitor the download traffic of each individual end host based on their internal LAN IP addresses. H...
