vlan and management subnet

[ino]

how can i have a router on a stick so that the router s ip (ssh/telnet) is 10.0.0.1 vlan7

the switch ip is 10.0.0.2 vlan7

AND and here where i got stuck i connect a computer to the switch ports on the router (not the switch) with ip 10.0.0.10

how do i need to set up the port for the computer

 

[balaji.bandi]

You can not do that unless you change the router to act as Bridge between PC and Switch.

Logically if the device in the same switch, i would provision another port in the switch with VLAN 7.

what is the goal or problem trying to solve, taking PC into Router port?

[paul driver]

Hello

Try the following:

[ino]

i have no IEEE

ast IBM protocol
dec DEC protocol
ibm IBM protocol
vlan-bridge vlan-bridge protocol

and it complaining that 

Spanning Tree protocol for Bridge Group 7 has not been configured.

i think i can ignore that for the moment

but what protocol should i use instead of ieee

the router is a c1111

also if i do the bridging will i see traffic in netflow?

thank you so far