Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

this is what i am getting when i run the backup Destination filename [ASA_Backup]?Cryptochecksum: f2bd649c 522e87c2 cadd73d5 6c17bfbb!!!!!!!!! but i can't find the source where it's been saved! either i look at TFTP queue and it's not showing there, ...

Hello Can you explain me the below NATs? object network HQsubnet 192.168.10.0 255.255.255.0object-group network INLINEnetwork-object 192.168.2.0 255.255.255.0network-object object HQobject network NET_OBJsubnet 172.16.255.0 255.255.255.240object netw...

We started working on Cisco Prime Infrastructure to see if it can simplify the version management on Cisco Catalyst switches. Prime Infra 3.8 is installed and running with Evaluation license. 9300 Switch (Bundle Mode) is added as network device into ...

NDP by Level 1
  • 1819 Views
  • 3 replies
  • 0 Helpful votes

What is the proper way to configure the TACACS+ server config on a C9410R (SUP1) running 16.12.3a?The config document says this formattacacs server <NAME>   address ipv4 <IP ADDRESS>   key <KEY> However, that's not an option on the switch. Below is t...

ROBERT T by Level 4
  • 1876 Views
  • 5 replies
  • 0 Helpful votes

Hi, I am configuring cisco ACS 5.8 and want to allow some specific command in command set while blocking its related commands. for e.g permit ping .* size 1000 permit ping .* count 500 I just want to allow above two argements with mentioned values...