Hello all, Something strange happened on our ASA recently. Maximum concurrent connection was reached and new connections were being dropped which caused service failure. Just hours before this, netflow was configured on the box and it is now a su...
Forum Posts
Hello, I am using the VM fore FireSIGHT, version as below: Cisco Fire Linux OS v6.1.0 (build 37) Cisco Firepower Management Center for VMware 6.1.0.6 (build 85) ASA versions: Cisco Adaptive Security Appliance Software Version 9.6(4)3 Device Manag...
we have two ASA 5550 firewalls at our datacenter in active-standby mode. But when we switch off active firewall, standby firewall doesnt takeover. To resolve outage we have to reboot standby firewall so that primary firewall takes over. hereby attac...
I am trouble shooting an issue where I see a lot of return traffic from web browsing getting denied. I am running an software version 9.6(4).6 with a Firepower module on board. I originally though it was due to closed (torndown) connections but d...
Hello,I just picked up 2x Cisco ASA 5515-X firewalls. At the time I thought they were identical, but there are some differences. One model has V01 on the sticker, in sh ver it is showing with 4GB Flash and running ASA 8.6(1)2. The second model is V04...
HiOn FMCv 6.2.2 and FTD 2110 ver.6.2.2, the cluster displays both FWs as active when it's active backup if I check the FTD CLI.There must be a bug in this version.Anyone have experienced something similar?Thanks
I have a HP printer on my Office VLAN ( 192.168.160.190) that I would like to create a virtual IP on my House VLAN at 192.168.150.190, to allow printing from the less secure House network to Office network. I need assistance with setting up the netw...
Hello, please need help setting up RSPAN between Catalyst 65500 and Catalyst 3560. I have configured the following command on both switch's but I'm not receiving any data in sniffer. 6K5 VLAN Name Status Ports---- -------------------------------- ---...
hi all,it is possible use 1 or 2 Gb memory with ASA 5505 or only 512 Mb ?Thanks
Hi Everyone, ASA1# sh run objectobject network Sales subnet 10.12.12.0 255.255.255.0ASA1# sh run object-groupobject-group service 123 service-object udp source eq 1900object-group service 1900 udp port-object eq 1900objec...
Resolved! Problem with ACL Edited with solution
The issue was that I didn't realize that I accidentally created the service with a source and destination port. The source port is randomly generated along a range of ports so, by designating a source port, I accidentally caused the access rule not t...
Resolved! Unable to install FTD patch 6.2.3.1
Hey everyone, I have a brand new FMC HA setup with two FTD's assigned. The FMC pair is running 6.2.3.1 and I'm now trying to put the patch on the FTD firewalls as well. When I try to upgrade I get an error. This is the log output: admin@dd-suc-fw01-s...
Hi all, I am not sure if this has been discussed or not. I am looking for recommendations on how to move some new Firepower service modules, which run on various ASA 5500-X's and performing only monitoring, from their currently registered virtual ...
Hi, I have a Firepower 2110 device with ASA OS 9.8(2) and FXOS 2.2(2.52). The datasheet says that this device has 12 Ethernet ports and 4 1G SFP maximum and I want to know which ports are Ethernet and which are SFP. When I do show interface it gives ...
