Network Security

Good Day All,  I had a searched thru the forums looking for a very specific answer, however I can find similar topics regarding to it, but still unable to solve the issue I am currently facing.  Looking at the above diagram, user from 192.10.10.0/...

I have a new Cisco ASA 5506-x firewall that came with FTD 6.1 image installed. I wanted to update to the latest 6.2 image before deploying it so I re-imaged the device. The device will be managed with the FMC console. The question that I have is that...

Our company is in the process of deploying the Cisco FireSIGHT managed firewall solution for customers. This will be a virtual implementation of Defense Center, NGIPS and ASA. In our setup there will be one dedicated per customer. Today we were discu...

Hi, i am struggling to get any audio when ringing from the outside pstn to an internal phone. we have a pbx service on the outside connecting via sip to an internal gateway. we see the sip trunk is up and we see udp connections built successfully w...

getting service card failure and VPN freezes up about once a month.ASA5525X/pri/act# sh failover his==========================================================================From State To State Reason==================================================...

Hi All, I am very confused about the config for the outside switches for active/standby asa with dual ISP connections. The image below is from the firewall and ips design CVD. If the ASA's outside interfaces are in the private address range how doe...

Hi,We have a project that consists on implementing FTD devices using FirePOWER Management Center (FMC 4000). In the implementation we need to configure packet marking using route map:  Here the configuration on the cisco ASA: ! access-list Data {st...

hi all, does anyone have the same problem with create Email Alert not possible on SFR Module? SNMP and Syslog is possible, but email not. to configure E-Mail Notification in the system policy is possible and I can send a testmail to me, but alertin...

I don't know too much about Cisco firewall, we are using ASA 5515-X for remote VPN (Anyconnect SSL VPN) with 100 user license.  I just want to know, Can we configure the same VPN service on Firepower with no extra license? Thanks

Hi, just want to know in ASA what is the more preferred route a PBR or a directly connected route? thank you very much

Do the licenses I bought for my 5505 transfer for no added fee to my 5506 when I upgrade?

Hi All, Would you be able to shed some light on the below error message?  If you could look at the screenshot attached, it will show you the current setup. I have set this up using the ASDM, the packet is being denied when going from:  Outside R1 to ...