Network Security

I've been trying to setup my Splunk Server and integrated to the Firesight, but I'm getting this error when setup CPAN: Can't locate CPAN.pm in @INC (@INC contains: /usr/lib/perl5/5.10.1/i386-linux /usr/lib/perl5/5.10.1 /usr/lib/perl5/site_perl/5.10....

i am working on a scenario, where we have two ASA5525X. Actually we have SCADA networks connected to Cisco 3850 Switches and These switches are connected to ASA5525X. As per my understanding, We need to apply access list in order to restrict the comm...

We have a pair of ASA 5525-X with no FirePOWER modules and was wondering if we should purchase two of these SSD drives: Micron_M600_MTFDDAK128MBF , one for primary and the second for standby. As for licenses (think of getting this - L-ASA5525-TAMC-1Y...

Hello Team! We have several FP 4120 appliances with 6.2.0 td software working in HA pairs. We have issue with FTP session on them, some how ftp inspec dosn't work. FP have ability as ASAs to inspect ftp session ?

Hello, I have a firewall rule( ACL) that allows connection between source 1.1.1.1 and destination 2.2.2.2 on any port. access-list outbound extended permit ip host 1.1.1.1 host 2.2.2.2 Question: If I remove above rule and add it back again(~after 1 m...

Hi I have an ASA5506W vith Ver 9.7.1 installed Trying to get anyconnect up and running. Anyconnect ver 4.3.04027-k9 made the ASA Reboot ver 4.3.05017-k9 the same I cant get any trafic through, But that's another problem.

I have upgraded Firepower to 6.2 on a new 5506-x firewall. I am having issues with the policies. The documentation says that there should be "Create Policy" button. I do not have one. I decided to just go ahead and add rules to the "Default Allow All...

It appears that I am not able to select Intrusion or File Policy in a rule unless the rule is an "Allow Rule" rule. It seems like the "Allow" means allow it to firepower for Analysis. Is that correct? If so does this mean that the Intrusion and File ...

I am observing frequent traffic from AWS cloud and Internet Public IPs towards my FMC .How can i check if it is genuine or not?

Hi I would appreciate any advice I am in the process of doing 3rd year project, I have 2 3560s configured for HSRP and spanning tree to maximise redundancy ie the odd vlan use 1 switch and even use the other.This means I have 2 networks on the inside...