Network Security

Dear All, I am using the ZBFW in my edge router. Users are behind firewall and NAT for the internal user networks configured on ASA 5510 which is running 8.4 image. I want to ssh to the zone based firewall inside interface in order to manager it from...

Hi, we have Cisco WLC 8510 and ISE appliance as RADIUS server, everything working fine but i found there is huge difference between WLC current client and ISE Dashboard Active Endpoints, its not properly sync.any help would be appreciated thank you,M...

Kindly help  to configure IPSEC Tunnel on Cisco ASA-5585

I am trying to configure SNMP v3 in the system policy of a FireSight 6.0 MC.  When I add the user and try to save the policy, I get the following webpage prompt: This policy includes access to port 161 (snmp), but no SNMP users have been added. SNMP ...

Hi all, have a quick question regarding Cisco IE 1.4 my client is on on the following Product : ISE - VM - K9version 1.4.0.253Role : standalone and has assign the following resources : 4 vCPURAM : 4096 MBDisk : 220GB however he is seen the following ...

Is there a migration tool or a command I can use to modify an exported file package from 5.4 to install on a new 6.0.1 sensor?

Hi, asa (route mode ) -----sniffer-------router---wan And in the sniffed traffic i can see source 10.0.15.121 and destination is 10.10.0.50 why i can see a private ip address? Thanks

Hi All  we are keep on getting this below error every day. Please help us to identify the issue behind this. Module Name Test Name Time Description Value Units Status DeviceProcess Status Process Status 2016-03-10 01:04:34 All processes are running c...

Hi guys,  today one of our Sourcefire sensors (3D8130) is giving us a hard time.  The error in Defense Center is Module Inline Link Mismatch. That led me to believe that probably the auto-negotiation is not working anymore. When i went in to disable ...

hi,  please help me about cisco firesight management center  after login cisco firesight management center dashboard is not showing anything, its blank totally.

Hi All, Hope you are doing good. When i do packet tracer in ASA. Am getting dropped at the point NAT(rpf-Check). But normally NAT has been allowed for this subnet. Could anyone please help me out to allow this NAT(rpf-Check) with commands are more ap...

I have a web and mail server in the DMZ (two separate IP addresses). I have a single External IP from my ISP, so I use Port Forwarding to direct traffic to each server depending on the port. I can access the web server by typing www.domainname.com. H...