Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello,We have a Cisco ASA 5510 which fails to respond.Its status led keeps blinking.I powered off and powered on the unit but the behavior is always the same.With a console connection, only this line is shown:  "Booting system, please wait..."Could a...

oalonso11 by Community Member
  • 27369 Views
  • 4 replies
  • 0 Helpful votes

We found an error when try to upgrade Network Sensor Patch. Any Idea what the cause? OUT: Verifying archive integrity...OUT: All good.OUT: Uncompressing Cisco Network Sensor Patch / Fri Mar 25 14:01:08 UTC 2016OUT: .OUT: .OUT: .OUT: .OUT: .OUT: .OUT:...

Hai I need to know whether clustering of two ASA 5545x- firepower  with cisco 6807xl(enterprise Lic) in VSS is possible.There is no DMZ  and firewalls need to be in transparent mode. I need to connect a switch to outside interface and put few servers...

Kevin100 by Level 4
  • 451 Views
  • 3 replies
  • 0 Helpful votes

We have an environment using class B networks where the third octet is used as a device type identifier. For example, a 60 in the third octet identifies a printer and a 92 is a desktop to be denied internet. We want to prevent printers from accessing...

b8mnr5401 by Community Member
  • 491 Views
  • 1 replies
  • 0 Helpful votes

Hi, I have some misunderstanding with ACL using service-object and port-object.Device is Cisco ASA ASA5510 Software Version 8.2(5).1 ACL using service-objectaccess-list PAT-all extended permit object-group Site-LAN-serObj-tcp object-group Site-LAN an...

Ritter Rs by Community Member
  • 4722 Views
  • 8 replies
  • 0 Helpful votes

CMGR PLAT: In sw_mod_idprom_resp_handler Failed to find idp resp PID for slot 1 CMGR VM: In cmgr_kvm_sw_mod_idp_req_thread, Failed to retrieve IDPROM data from software module 1 This problem has rendered 3 of our ASA5555x out of service. Please help ...

nilambhate by Community Member
  • 2470 Views
  • 6 replies
  • 0 Helpful votes

Hello all, I have seen that the ip inspect feature sends sometimes some RST packets. I would like to know if it was possible to keep the ip inspect feature enabled and doing its job but without sending the RST packets. I do not have the customer's co...

tscaon001 by Community Member
  • 488 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card